Fishing Forum

hi guys as promise the pics
i hope you can see and understand them now
this is of the frame i made from stainless steel


i used a wheel whit the size 12½ x 2¼
and attached it like this




i didn't put the boat together for the picture
but if you inmagined the pontoons to it you get the picture




and this are the closer pics of the rodholders

this one



is this one is this


and this


is this one that i use for drifting fishing or just to have my hands free for whatever



i hope you get it now

johan
[signature]

Hey johan-p,

Wow, nice wheel set-up ! Are you a welder ? You've given me some ideas for mine as well. I've been working on making one for my pontoon for a while now but I don't have all the parts yet - I'm going to use an old bicycle wheel on mine.

Also, thanx for the close-up picture of your rod/net holder - I can see how it constructed now. Nice work !
[signature]

[cool][#0000ff]Nice work. Thanks for sharing. Some of those pictures will definitely be going into our picture board when I get some time to work on it again.[/#0000ff]
[#0000ff][/#0000ff]
[#0000ff]Now let's hope you can take it all on the water and catch some fish.[/#0000ff]
[signature]

@ fishhound
i am no welder i let the job done on my work
it's not easy to weld stainless steel and at my work are some guys who know how to do it

@ tube dude
i made some better pictures of al the stuff if you want o use them
let me know then i will send you them in a higher quality

and here is a pic
when its ready
the wheel setup




johan
[signature]

[cool][#0000ff]That looks good. Thanks.[/#0000ff]
[#0000ff][/#0000ff]
[#0000ff]Since I need to reduce the pics down in size, larger resolution is not what I need. I think I can use the ones you have sent. I am doing some upgrades to the Picture Board this week.[/#0000ff]
[signature]