10-29-2005, 01:34 AM
I have a small jon boat that is leaking at the rivets. What is the best way to fix my leaks. I have heard the Gorrila Glue works but I am looking for other suggestions.
[signature]
[signature]
10-29-2005, 01:34 AM
10-29-2005, 02:29 AM
Rhino liner. You can buy a pint jar at checkers.
[signature]
[signature]
10-29-2005, 03:17 PM
I have used JB weld, and it seems to work fine. But the bed liner suggestion is the way I would do now if were going to do it again.
[signature]
[signature]
10-31-2005, 02:26 PM
Rhino Liner,? Would i use it to cover just the spots that are leaking or do the whole boat? Would I do the inside or outside?
[signature]
[signature]
11-03-2005, 08:23 PM
Hey I still need some help on this. Anyone please..
[signature]
[signature]
11-03-2005, 10:25 PM
kidsnme,
Sorry I took so long to reply to your question, I only look at this board once a week or so. Anyways as for your question I think you could just cover around the holes that are leaking. Rhino liner is like a thick paint and goes on thick. I took mine to Rhino Liner shop and they sprayed it in. It is very nice looking and they textured the surface so its not slippery. Mine is white and dont heat up in the sun. I also have lined my truck tool box with the stuff from checker. And it sealed up the cracks in this good. The prep work was just al ittle sanding and then I just rolled it on.
[signature]
Sorry I took so long to reply to your question, I only look at this board once a week or so. Anyways as for your question I think you could just cover around the holes that are leaking. Rhino liner is like a thick paint and goes on thick. I took mine to Rhino Liner shop and they sprayed it in. It is very nice looking and they textured the surface so its not slippery. Mine is white and dont heat up in the sun. I also have lined my truck tool box with the stuff from checker. And it sealed up the cracks in this good. The prep work was just al ittle sanding and then I just rolled it on.
[signature]