01-08-2009, 04:54 AM
Just thought I would share with you a project I have been working on for a portable windbreak.
This was made with 3/4" pvc. I had most of the stuff already so I don't know what the cost would be, but I am sure it would still be reasonable.
The bottom part of the rack is semi permanant on the sled and the rest comes apart and goes into the duffle for transporting. I do believe it will easily pull around while set up if the wind isn't to bad, (haven't tried it out yet, this Saturday will be it's debue)
The wooden box (need to figure out a lighter storage system, there) holds the rods, gear, sonar and bait. The buckets hold my tipdowns and misc.
There are 2 buckets one will be for fish the other is 2 buckets combined with the bottom cut out of one and screwed together (made a taller bucket to sit on and for the gear), the lid has had all but 2 of the "latches" cut off, easier to work in the cold with.[
]
The ice spoons have just had the foam put on as last weekend one of mine slid down the hole after I set it down on the bench[mad]
I hope to figure out a rod rack but not sure if it will be on the sled, frame or the bench.
[signature]
This was made with 3/4" pvc. I had most of the stuff already so I don't know what the cost would be, but I am sure it would still be reasonable.
The bottom part of the rack is semi permanant on the sled and the rest comes apart and goes into the duffle for transporting. I do believe it will easily pull around while set up if the wind isn't to bad, (haven't tried it out yet, this Saturday will be it's debue)
The wooden box (need to figure out a lighter storage system, there) holds the rods, gear, sonar and bait. The buckets hold my tipdowns and misc.
There are 2 buckets one will be for fish the other is 2 buckets combined with the bottom cut out of one and screwed together (made a taller bucket to sit on and for the gear), the lid has had all but 2 of the "latches" cut off, easier to work in the cold with.[

The ice spoons have just had the foam put on as last weekend one of mine slid down the hole after I set it down on the bench[mad]
I hope to figure out a rod rack but not sure if it will be on the sled, frame or the bench.
[signature]