Fishing Forum

I finally got the engine mount trolling motor put in the Four Winns. The cable is plenty long enough to run over the top of the boat, but I want to run it under the swim deck somewhere next to where the upper unit enters the boat to clean things up and make it safer to use.

I figure I'll need to use a firewall grommet for a seal, but really have no idea what is the best way to drill the hole and then make sure it's sealed well.


[signature]

i would advise not to drll a hole near or below the water line.

here is something that will help you if you still want to


[url "http://www.boat-project.com/tutorials/drill.htm"]http://www.boat-project.com/tutorials/drill.htm[/url]
[signature]

Thanks for the link. It'll be plenty far out of the water even when heavily loaded. There's a spot that still has cobwebs and dirt from last year even after a couple days on the water that should be safe for the hole.
[signature]