06-13-2015, 05:00 PM
How are you guys mounting troling motors to your tubes? Also how are you mounting the PVC I have been looking at pics but can't seem to figure it out.
[signature]
[signature]
06-13-2015, 05:00 PM
06-13-2015, 08:29 PM
[#0000FF]I just attached a writeup on adding rod holders to Trout Lover's question. That should provide some useable info on that situation.
Motors are a different matter. All tubes are different and it takes enough room behind the seat to hold a battery. Then you usually have to add floatation to stabilize the front/back end.
Send me a PM with your email address and I will send you something that should help. Can't send big files with PMs.
[/#0000FF]
[signature]
Motors are a different matter. All tubes are different and it takes enough room behind the seat to hold a battery. Then you usually have to add floatation to stabilize the front/back end.
Send me a PM with your email address and I will send you something that should help. Can't send big files with PMs.
[/#0000FF]
[signature]
06-15-2015, 03:47 AM
Mine have a Motor Mount as an accessory so no fabricating, here, but TD has this down to a science.
[signature]
[signature]
06-15-2015, 04:17 AM
What kind of tube do you have?
[signature]
[signature]