Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
down rigger help
#6
[font "Comic Sans MS"][#800000]If you run both 5 feet or less behind the weight and DR Cable and 10 feet or more apart, you will absolutely eliminate tangles. Some folks use the 100 foot rule where the depth and distance behind the weight must total 100 feet. Hogwash. Run 'em no more than 5 feet behind the ball/cable at anything below 15 feet and you'll still catch 'em.[/#800000][/font]
[font "Comic Sans MS"][#800000]
[/#800000][/font]
[font "Comic Sans MS"][#800000]I run 4 DR's and run 'em short all the time. Way less headaches with tangles that way. Still catching them that way.[/#800000][/font]
[font "Comic Sans MS"][#800000]
[/#800000][/font]
[font "Comic Sans MS"][#800000]Tight lines. [fishin][/#800000][/font]
[signature]
Bob Hicks, from Utah
I'm 82 years young and going as hard as I can for as long as I can.
"Free men do not ask permission to bear arms."
Reply


Messages In This Thread
down rigger help - by PACMEN - 06-30-2018, 04:16 AM
Re: [PACMEN] down rigger help - by Elkslayer1 - 06-30-2018, 05:06 AM
Re: [Elkslayer1] down rigger help - by PACMEN - 06-30-2018, 02:08 PM
Re: [PACMEN] down rigger help - by Jmorfish - 06-30-2018, 05:20 AM
Re: [Jmorfish] down rigger help - by PACMEN - 06-30-2018, 02:16 PM
Re: [PACMEN] down rigger help - by dubob - 06-30-2018, 11:47 PM
Re: [dubob] down rigger help - by PACMEN - 07-01-2018, 08:23 PM
Re: [PACMEN] down rigger help - by wyoguy - 07-02-2018, 09:08 PM
Re: [PACMEN] down rigger help - by OCF - 07-03-2018, 12:23 AM
Re: [PACMEN] down rigger help - by dubob - 07-03-2018, 02:04 PM
Re: [PACMEN] down rigger help - by mtncat1 - 07-01-2018, 04:57 AM
Re: [mtncat1] down rigger help - by fish_hntr - 07-01-2018, 06:02 AM
Re: [fish_hntr] down rigger help - by mtncat1 - 07-02-2018, 01:45 AM
Re: [PACMEN] down rigger help - by Theekillerbee - 07-02-2018, 01:51 AM
Re: [PACMEN] down rigger help - by liketrolling - 07-02-2018, 10:49 PM
Re: [liketrolling] down rigger help - by dubob - 07-03-2018, 02:43 PM

Forum Jump:


Users browsing this thread: 2 Guest(s)