10-25-2018, 02:20 PM
[quote Bduck]If you know where the drain plugs to your engine block and manifolds would be easy enough to drain. Or if your going to be near an outside power source you can take a clip on shop light replace it with a heat lamp for bilge area. I always drained my engine block and manifold. As far as the outdrive lower it for draining or water will stay trapped. This will be the most exposed area to freezing.[/quote]
I know how to drain it, but usually catch my knuckles on the end of one of the worm clamps just above the left rear manifold plug. Hmm, I can rotate that clamp away from the plug!! Maybe even see if I can replace the brass plugs with the plastic type that twist by hand.
[signature]
I know how to drain it, but usually catch my knuckles on the end of one of the worm clamps just above the left rear manifold plug. Hmm, I can rotate that clamp away from the plug!! Maybe even see if I can replace the brass plugs with the plastic type that twist by hand.
[signature]