New tube, rigging ?

[TubeDude]

Finished prototype ready for field testing.


2nd prototype ready for field testing.  No sounder on this one yet.  This one in ABS because I had most all the fittings but one "T" already.  The back swept rod holders are to keep the rods low and out of the way.  The drink holder was an afterthought when I saw the fitting.  I don't know if I will make this one "L" shaped like the PVC or if I will use a couple of 22 angle fittings to make it curve around the tube to be more stable.

You've been busy.  Looks like you know your way around PVC and ABS.  Next is to get out on the water and see how it fishes.  As I can attest, once you get started it never ends.  Always some little tweak or addition you think of while on the water...and then work it out after you get home again.