Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Mantua drive by 12/6
#15
(12-08-2020, 10:43 PM)BURLEY Wrote:
(12-08-2020, 09:51 PM)Springbuck1 Wrote: If Mantua is ACTUALLY 5", that's where I'll be tomorrow, I think. 

5" of ice is just happens to be the perfect amount to drill through with a hand auger.......
After reading your post, I grabbed my K-drill and a tape and went up to actually get a measurement of the ice. As I stepped onto the ice, my *ice* was puckered tight. The ice was very clear and looked like two- 1 1/2 in. layers as shown by the many fractures. I slowly went out to about 100 feet from the ramp. This was the distance a man and his son was fishing. A tent was set up out about 100 yards. I drilled a hole. It was hardly deep enough to call a hole. It was 3 1/4 inch. I picked up my drill and headed back to shore. Too thin for me to go out any farther.
Thanks, Burley.  5" is plenty, 3.5" is not even close.  It sounded too good to be true, given the speed ice forms downward from the bottom, but I wanted to believe.
Reply


Messages In This Thread
Mantua drive by 12/6 - by BURLEY - 12-06-2020, 09:47 PM
RE: Mantua drive by 12/6 - by Jmorfish - 12-07-2020, 06:18 AM
RE: Mantua drive by 12/6 - by obifishkenobi - 12-07-2020, 02:02 PM
RE: Mantua drive by 12/6 - by SkunkedAgain - 12-07-2020, 02:30 PM
RE: Mantua drive by 12/6 - by EyLayo - 12-07-2020, 03:44 PM
RE: Mantua drive by 12/6 - by Springbuck1 - 12-07-2020, 09:32 PM
RE: Mantua drive by 12/6 - by BURLEY - 12-07-2020, 10:20 PM
RE: Mantua drive by 12/6 - by kentofnsl - 12-08-2020, 12:51 AM
RE: Mantua drive by 12/6 - by BURLEY - 12-08-2020, 01:28 AM
RE: Mantua drive by 12/6 - by Fritzfishin - 12-07-2020, 10:56 PM
RE: Mantua drive by 12/6 - by BURLEY - 12-07-2020, 11:04 PM
RE: Mantua drive by 12/6 - by SkunkedAgain - 12-08-2020, 02:00 PM
RE: Mantua drive by 12/6 - by FatBiker - 12-10-2020, 04:34 PM
RE: Mantua drive by 12/6 - by Springbuck1 - 12-08-2020, 09:51 PM
RE: Mantua drive by 12/6 - by BURLEY - 12-08-2020, 10:43 PM
RE: Mantua drive by 12/6 - by Springbuck1 - 12-08-2020, 11:14 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)