|
Riveted hull repair ?
|
04-20-2021, 02:53 AM
if you can access the rivet then use a pneumatic rivet gun. it is a 2 person job. one to support from underneath and one to hammer them from above. If you can't access them then the closed end rivets are the way to go. I have bought them online. drill old rivet out and replace. some add a touch of sealant to the rivet but I have not. If you have 3/16" you can pop them with a standard hand tool. 1/4" will need a pneumatic/powered or a large rivet gun.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Riveted hull repair ? - by Tin-Can - 04-17-2021, 04:03 PM
RE: Riveted hull repair ? - by elkantlers - 04-17-2021, 09:28 PM
RE: Riveted hull repair ? - by castnshoot - 04-17-2021, 11:46 PM
RE: Riveted hull repair ? - by TiteLines - 04-18-2021, 01:57 AM
RE: Riveted hull repair ? - by Gone Forever - 04-18-2021, 03:04 PM
RE: Riveted hull repair ? - by Tin-Can - 04-18-2021, 03:59 PM
RE: Riveted hull repair ? - by steelhawk - 04-18-2021, 07:37 PM
RE: Riveted hull repair ? - by FishfulThinkin - 04-18-2021, 09:56 PM
RE: Riveted hull repair ? - by Gone Forever - 04-19-2021, 01:27 PM
RE: Riveted hull repair ? - by Tin-Can - 04-19-2021, 02:57 PM
RE: Riveted hull repair ? - by Mildog - 04-19-2021, 04:24 PM
RE: Riveted hull repair ? - by Outfishing13 - 04-19-2021, 04:57 PM
RE: Riveted hull repair ? - by Catdaddygarlic - 04-19-2021, 09:52 PM
RE: Riveted hull repair ? - by unluckytwo - 04-20-2021, 02:53 AM
RE: Riveted hull repair ? - by Realtorinutah - 04-20-2021, 03:33 PM
|
