(10-22-2022, 11:04 PM)MrShane Wrote:(10-22-2022, 06:11 PM)kentofnsl Wrote: Does anyone know of a mobile boat mechanic that would work on my boat near Bountiful? My trim motor is working, but raises the outboard really slowly, until it raises it a couple inches and then it works great. I hate to haul it all the way up to Lee (Lee's Marine) and have to wait a few weeks to get it repaired.
Hi Kent,
You may already know the difference here so just tell me to get lost if needed….
Outboards have trim/tilt feature built in.
The first few inches is ‘trim’ and is slower by design than ‘tilt’.
Trim is to be used while under power while tilt is not to be used under power and is only to raise LU out of danger zone/trailering.
Unless your ‘trim’ is painstakingly slow, it is functioning properly to have two ‘speeds’ of raising your motor.
Hope this helps?
The trim is painstakingly slow, to the point I'm afraid it isn't going to work at all.
(10-22-2022, 09:31 PM)doitall5000 Wrote: I have used this guy last spring. He works out of his house and off his truck. Did me a good Job over hauled the bottom of my motor. Not cheep but fixed it in one week. And it still runs fine.
801-712-2132
1504 west sunset Ave.
Wvc
Don't remember his name, give him a call.
Good luck
Thanks, I will contact him.