As someone very familiar with 3D printing, PLA (the most common filament) is not known for it's UV or heat resistance.
A hot day in direct sunlight could seriously compromise the strength and integrity of the filament. Additionally, anything less than 100% infill would lack necessary strength, in my opinion.
Maybe you are using different filament and already addressed the 100% infill, if so, my comment is not relevant. Otherwise, I'll say "I told you so" when you lose your rod.
A hot day in direct sunlight could seriously compromise the strength and integrity of the filament. Additionally, anything less than 100% infill would lack necessary strength, in my opinion.
Maybe you are using different filament and already addressed the 100% infill, if so, my comment is not relevant. Otherwise, I'll say "I told you so" when you lose your rod.