|
rod handles (cork)
|
06-02-2004, 06:17 PM
Haven't heard about the cork preservative. However, when one of my rod handles (cork or foam) starts to breakdown or show signs of wear, I simply use 1inch "heat shrink" and cut it to the desired length. Then heat it up and it shrinks around the old handle. Makes for a nice "rubberized feel. I buy it at an electrical supply store. Just an idea... [
 ][signature] |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
rod handles (cork) - by Chip_Flipper - 06-02-2004, 05:38 PM
Re: [Chip_Flipper] rod handles (cork) - by Bowfin - 06-02-2004, 06:16 PM
Re: [Chip_Flipper] rod handles (cork) - by BEARCLAW - 06-02-2004, 06:17 PM
Re: [Chip_Flipper] rod handles (cork) - by TubeDude - 06-02-2004, 06:21 PM
Re: [TubeDude] rod handles (cork) - by Chip_Flipper - 06-02-2004, 08:07 PM
Re: [Chip_Flipper] rod handles (cork) - by gshadow - 06-02-2004, 08:26 PM
Re: [Chip_Flipper] rod handles (cork) - by HFT - 06-02-2004, 06:51 PM
|
