Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Bass On a fly
#13
I do tie my own poppers. Where I live in Idaho the bass are generally small so the poppers are pretty small also. I do not know exactly what size they are but I tie most lf mine on a size 8 hook. I order or buy the bodies pre shaped. If you do not buy wide gap hooks then you have to cut a little away from the gap so that the hook can work on bass. The foam ones are the easiest to use because you just tie in a tail or legs with a wrapped hackle to disguise the hook a little and then glue the body on the hook. The only tricky part is heating up a needle to burn a hole in the body. Then you use a bobbin threader to pull the rubber legs through the body.

Windriver
[signature]
Reply


Messages In This Thread
Bass On a fly - by Xmlfish - 04-25-2007, 04:29 PM
Re: [Xmlfish] Bass On a fly - by Scruffy_Fly - 04-25-2007, 05:16 PM
Re: [Xmlfish] Bass On a fly - by idahopanfish - 04-25-2007, 06:50 PM
Re: [idahopanfish] Bass On a fly - by Dryrod - 04-25-2007, 07:57 PM
Re: [Dryrod] Bass On a fly - by tubeN2 - 04-26-2007, 03:35 AM
Re: [Xmlfish] Bass On a fly - by flygoddess - 04-25-2007, 07:51 PM
Re: [flygoddess] Bass On a fly - by macfly55 - 04-25-2007, 07:55 PM
Re: [Xmlfish] Bass On a fly - by tubeN2 - 04-26-2007, 03:42 AM
Re: [Xmlfish] Bass On a fly - by macfly55 - 04-26-2007, 05:33 AM
Re: [macfly55] Bass On a fly - by Xmlfish - 04-26-2007, 05:38 AM
Re: [Xmlfish] Bass On a fly - by windriver - 04-26-2007, 07:51 PM
Re: [windriver] Bass On a fly - by Dryrod - 04-26-2007, 08:11 PM
Re: [Dryrod] Bass On a fly - by windriver - 04-26-2007, 08:22 PM
Re: [windriver] Bass On a fly - by Dryrod - 04-26-2007, 10:55 PM
Re: [Dryrod] Bass On a fly - by Xmlfish - 04-26-2007, 11:36 PM
Re: [Xmlfish] Bass On a fly - by Dryrod - 04-27-2007, 02:48 PM
Re: [Xmlfish] Bass On a fly - by tubeN2 - 04-30-2007, 04:39 AM
Re: [tubeN2] Bass On a fly - by SC_flyguy - 05-01-2007, 04:53 AM
Re: [SC_flyguy] Bass On a fly - by tubeN2 - 05-01-2007, 05:44 AM

Forum Jump:


Users browsing this thread: 3 Guest(s)