05-23-2007, 07:11 PM
Sounds kinda like the rig you spelunked for me a few weeks ago. [
] Instead of stuffing that extra wire in the pocket, I wrapped it around the tube and secured it with zip ties. Then I put a hard plastic open-topped thing in the pocket to keep the battery more secure and the tube material separate from the battery. I cut a hole in the top of the divider between the back and middle pockets to make it easier to load and unload the battery since the zipper on the back pocket is a bit of a tight squeeze for it.
[inline "Side View.jpg"]
[inline "Cable Wrap.jpg"]
[inline "Rear Pocket View.jpg"]
Hands down, you are the PVC master. Perhaps someday if I sniff enough fumes from the PVC glue, I can learn to think as you think! Thanks again for the help and I'm excited to see your new tool setup.
[signature]
] Instead of stuffing that extra wire in the pocket, I wrapped it around the tube and secured it with zip ties. Then I put a hard plastic open-topped thing in the pocket to keep the battery more secure and the tube material separate from the battery. I cut a hole in the top of the divider between the back and middle pockets to make it easier to load and unload the battery since the zipper on the back pocket is a bit of a tight squeeze for it. [inline "Side View.jpg"]
[inline "Cable Wrap.jpg"]
[inline "Rear Pocket View.jpg"]
Hands down, you are the PVC master. Perhaps someday if I sniff enough fumes from the PVC glue, I can learn to think as you think! Thanks again for the help and I'm excited to see your new tool setup.
[signature]