10-11-2008, 03:49 PM
Here's what I came up with - works well but I think there's still room for improvement, especially in the line storage/control area:
![[Image: DSCF9152.jpg]](http://i160.photobucket.com/albums/t177/shigspeed/Fishing/Tube%20Mods/DSCF9152.jpg)
![[Image: DSCF9153.jpg]](http://i160.photobucket.com/albums/t177/shigspeed/Fishing/Tube%20Mods/DSCF9153.jpg)
The PVC tee fitting I cut and it snaps right on any part of the frame of my 'toon. This way I can use the location of the mount to tailor the orientation of the craft to the wind.
The winder is a kite line winder card. A little undersized for the rope and amount of rope on it. Ideally I'd like a spool that floats but isn't bulky in case the whole mess falls in the water.
Comments?
_SHig
[signature]
The PVC tee fitting I cut and it snaps right on any part of the frame of my 'toon. This way I can use the location of the mount to tailor the orientation of the craft to the wind.
The winder is a kite line winder card. A little undersized for the rope and amount of rope on it. Ideally I'd like a spool that floats but isn't bulky in case the whole mess falls in the water.
Comments?
_SHig
[signature]