03-03-2009, 12:56 PM
As another mentioned get a tea kettle where once the water starts to boil the steam will emanate from the little hole in the cap. Grasp the section of rod section with the bad "set" with a cloth on each side so the steam won't burn you. Then hold the warped section about 4" - 6" above the steam jet gently bending it in the opposite direction of the set or warp. Hold it in the bent position for awhile and move it away from the steam, once it cools you can loosen your grip and you will surely see a significantly reduced warped area, Repeat if you still need to remove some warpage.
[signature]
[signature]