Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Willard Ice
#17
I really wanted to let those ponies loose in back but had to hang on. I had changed oil as well as greased every thing and found my reverse bucket was dropping to easy so it is back to making adjustments. Have to add some friction where the grease had removed it. The marina is mostly 7-9 feet deep except for a hump between the docks and the main channel. The main channel out to the ice was 14 feet deep. It will be hard to fish from shore in most places because there are a lot of tumble weeds sunk around shore. If the lake fills i would expect about 25 feet in the marina. i would love to see it full.
[signature]
Reply


Messages In This Thread
Willard Ice - by trout_slayer - 03-21-2009, 06:55 PM
Re: [trout_slayer] Willard Ice - by trout_slayer - 03-21-2009, 07:39 PM
Re: [trout_slayer] Willard Ice - by Theekillerbee - 03-21-2009, 07:47 PM
Re: [Theekillerbee] Willard Ice - by trout_slayer - 03-21-2009, 08:05 PM
Re: [Theekillerbee] Willard Ice - by trout_slayer - 03-21-2009, 08:37 PM
Re: [trout_slayer] Willard Ice - by ateve1 - 03-21-2009, 08:40 PM
Re: [ateve1] Willard Ice - by fishinfool - 03-21-2009, 08:55 PM
Re: [trout_slayer] Willard Ice - by fishinfool - 03-21-2009, 08:56 PM
Re: [fishinfool] Willard Ice - by reelfast - 03-22-2009, 01:36 AM
Re: [reelfast] Willard Ice - by fishinfool - 03-22-2009, 02:14 AM
Re: [reelfast] Willard Ice - by d-mack - 03-22-2009, 02:17 AM
Re: [d-mack] Willard Ice - by reelfast - 03-22-2009, 02:33 AM
Re: [reelfast] Willard Ice - by fishinfool - 03-22-2009, 03:09 AM
Re: [fishinfool] Willard Ice - by wiperhunter2 - 03-22-2009, 05:46 AM
Re: [trout_slayer] Willard Ice - by mme1 - 03-21-2009, 09:04 PM
Re: [mme1] Willard Ice - by ateve1 - 03-21-2009, 09:07 PM
Re: [ateve1] Willard Ice - by mme1 - 03-21-2009, 09:20 PM
Re: [ateve1] Willard Ice - by kochanut - 03-21-2009, 09:24 PM
Re: [kochanut] Willard Ice - by ateve1 - 03-21-2009, 10:38 PM
Re: [trout_slayer] Willard Ice - by TheFishSlayer - 03-29-2009, 08:12 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)