Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Fat Cat Ferrari (first pics)
#12
Good ideas all.
I saw the handle. I am not sure that I would like it that close to me.

I have thought about just a straight "half length" extension out of pvc, not enough to get in the way of tilt, but enough to make my "twist and reach" easier on the Renegade.

I am not sure, but I think the Fish Cat is a little shorter length wise in the back than the Fat Cat. On the Fish Cat I can reach my handle without a problem up over my shoulder.

My little motor only has three speeds, and so far I mainly just use #1. I am thinking of putting in a small power switch off of the battery cable as someone did before on this forum. I am not sure who it was though. I know that FlyGoddess put on a complete remote rheostat, so that the controls are up front. I'll have to look up those posts.
[signature]
Reply


Messages In This Thread
Fat Cat Ferrari (first pics) - by TubeDude - 05-04-2010, 02:27 PM
Re: [TubeDude] Fat Cat Ferrari (first pics) - by cpierce - 05-04-2010, 06:08 PM

Forum Jump:


Users browsing this thread: 5 Guest(s)