Lindon Renegade

[TubeDude]

[cool][#0000ff]Sheesh. You sure are fulla questions...or fulla something.[/#0000ff]
[#0000ff][/#0000ff]
[#0000ff]No idear why the report got locked on the Utah board. Can't figure out the "logic" of the current set of moderators. Glad I got out of that job in Utah.[/#0000ff]
[#0000ff][/#0000ff]
[#0000ff]The "chip and seal" work is mostly done for this season, but it probably wouldn't constitute much of a potential problem anyway. That cover on the frameless and bladderless Renegade could probably deflect RPGs. [/#0000ff]
[#0000ff][/#0000ff]
[#0000ff]For the trial run I "adapted" my float tube rod holders and tool rack setup for the Renegade. I threw together a measured-to-fit base and then used the strap-on pockets to secure the base in place. After that it was simply popping on the respective fittings. When I get one for my ownself I am likely to make some adjust-a-ments.[/#0000ff]
[#0000ff][/#0000ff]
[#0000ff]TubeBabe has been out of town and hasn't seen or tried the Renegade yet. But she has seen the [url "http://www.youtube.com/watch?v=CiYXAAVGK_M&feature=related"]Dave Scadden Videos[/url] and only asked a couple of "comfort" questions. We both had H3 float tubes made by him and for some reason we could never fish very long in them without "butt cramps" and aching backs...no matter how we adjusted them. I assured her I would pay special attention to that detail and so far I am good widdit. But she will have to make her (my) own decision on that.[/#0000ff]
[#0000ff][/#0000ff]
[#0000ff]Sheesh.[/#0000ff]
[signature]