07-27-2012, 05:16 AM
Ok the old man is trying the album way . [:p]
Trailer Mods - was a trailer with 5' rear gate and 2' rails on 3 sides. Rollers are pvc with 3 bearings pressed inside on 1/2" aircraft ( 7075) aluminum rods. Deck covered with marine carpet. Between rollers 2 pcs of 3/4 " plywood glued / screwed together then covered in same carpet . Top of rollers 1/2" - 3/4 " above plywood pcs. 4 Hvy duty eyebolts on each side.
![[Image: IMG_07391.JPG]](http://www.bigfishtackle.com/photos/data/822/IMG_07391.JPG)
The anchor pulley on back rail needs to be removed for a motor mount ( nedd to fabricate one ) and relocated .
In process of figuring an accessories rail for fishfinder / rod holders / transducer mount / net holder / light bar. I think the beer will have to go in pockets of life preserver jacket . [
]
Sleigh Ride sounds fun although with my luck lately I'll end up with one on my lap.
I think I need to reduce picture size some more - better on 2nd try.
![[Image: cataraft2.jpg]](http://www.bigfishtackle.com/photos/data/822/medium/cataraft2.jpg)
![[Image: cataraft_1.jpg]](http://www.bigfishtackle.com/photos/data/822/medium/cataraft_1.jpg)
[signature]
Trailer Mods - was a trailer with 5' rear gate and 2' rails on 3 sides. Rollers are pvc with 3 bearings pressed inside on 1/2" aircraft ( 7075) aluminum rods. Deck covered with marine carpet. Between rollers 2 pcs of 3/4 " plywood glued / screwed together then covered in same carpet . Top of rollers 1/2" - 3/4 " above plywood pcs. 4 Hvy duty eyebolts on each side.
The anchor pulley on back rail needs to be removed for a motor mount ( nedd to fabricate one ) and relocated .
In process of figuring an accessories rail for fishfinder / rod holders / transducer mount / net holder / light bar. I think the beer will have to go in pockets of life preserver jacket . [
]Sleigh Ride sounds fun although with my luck lately I'll end up with one on my lap.
I think I need to reduce picture size some more - better on 2nd try.
[signature]