02-22-2014, 06:01 AM
Don't sand it that hard. 400 grit will work. Just scuff the shine off.
I am not sure of the hole in the frame question. The glue on mount is a pad with the center raised about 2" x 4" in the middle (not sure of exact measurements) where the rod holder base will be screwed on when done. So I basically made a rectangle box that went around this raise area to apply pressure to the pad.
[url "http://www.scotty.com/fishing-gear-equipment/rod-holders/glue-onmount.htm"]http://www.scotty.com/fishing-gear-equipment/rod-holders/glue-onmount.htm[/url]
[signature]
I am not sure of the hole in the frame question. The glue on mount is a pad with the center raised about 2" x 4" in the middle (not sure of exact measurements) where the rod holder base will be screwed on when done. So I basically made a rectangle box that went around this raise area to apply pressure to the pad.
[url "http://www.scotty.com/fishing-gear-equipment/rod-holders/glue-onmount.htm"]http://www.scotty.com/fishing-gear-equipment/rod-holders/glue-onmount.htm[/url]
[signature]