Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Going to pimp my Assault XX
#4
Running a motor AND an anchor is a different story, however, you can still put a Scotty anchor on the front. On the bottom of the boat on both ends there are two maybe nickel size holes. You have to make them a little bigger for the Scotty straps.
You will need one of these mounts (minus the rod holder) for a TUBE
[url "http://www.scotty.com/fishing-gear-equipment/rod-holders/fly-rod.htm"]http://www.scotty.com/fishing-gear-equipment/rod-holders/fly-rod.htm[/url]

To run a motor and an Anchor, you might have to use some imagination. Hubby put a bigger motor plate on the NFO motor mount and put his electric motor and the anchor.
[Image: IMG_3901.jpg]

For clean out of the way Scotty mounts get these and glue it on with Loctite for Vinyl
[url "http://www.austinkayak.com/products/4053/Scotty-341-Glue-on-Mount-for-Inflatables.html"]http://www.austinkayak.com/products/4053/Scotty-341-Glue-on-Mount-for-Inflatables.html[/url]

For Camera, I have one of these:
[url "http://www.austinkayak.com/products/6567/Scotty-Portable-Camera-Mount-135.html"]http://www.austinkayak.com/products/6567/Scotty-Portable-Camera-Mount-135.html[/url]

Here is mine on a glue on pad
[Image: IMG_4208.jpg]


Scotty makes just about everything you could need and I like dealing with Austin Kayak.

They also make sonar mounts.

I made my own with a 2" nylon strap and quick clips, a flexible cutting board and RAM mount and Hummingbird mount. Pricy but slick.
[Image: 034_zps03195bc5.jpg]

Sky is the limit!
[signature]
Reply


Messages In This Thread
Going to pimp my Assault XX - by atvaholic - 03-13-2014, 01:56 AM
Re: [atvaholic] Going to pimp my Assault XX - by flygoddess - 03-13-2014, 09:15 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)