04-09-2014, 01:42 AM
Duh! Sorry, yes it swivels. I too was using PVC but felt like it was wiggling specially on this boat. I also use this mount on my Assault so that is why it is so long. I use the next hole up on the Assault. Then on my X5 I have a little bigger square tubing mounted to my deck, and I slide this in to that.
My original mobile mount is a flexible cutting board that I cut slits and threaded the 2" wide nylon strapping through. I can adjust length at the quick clips on the end.
I burnt a hole in the strapping and used a 2" Carriage Bolt. The round end towards to boat, but I also put Velcro over the bolt head so it will not wear on the boat.
2" washers and a wing nut on the out side so I can tighten and loosen by hand.
I cut the cutting board down for this boat, but not sold on the location yet.
[signature]
My original mobile mount is a flexible cutting board that I cut slits and threaded the 2" wide nylon strapping through. I can adjust length at the quick clips on the end.
I burnt a hole in the strapping and used a 2" Carriage Bolt. The round end towards to boat, but I also put Velcro over the bolt head so it will not wear on the boat.
2" washers and a wing nut on the out side so I can tighten and loosen by hand.
I cut the cutting board down for this boat, but not sold on the location yet.
[signature]