09-15-2014, 04:04 PM
Component Systems is by far the best paint to use. Their clear coat can be mixed per TD with the glow powder. Since it is water based, you don't have to use it all when mixed.
As to your sprue. Move it off center so that it hits the mold at an angle, below the front of the jig. That way you can put the ring where you want w/o having to deal with the sprue. It should not make a difference in the pour as long as your lead is the proper temp !!
One last thing, I have several blank molds ( Do It ) if you desire to make your molds permanent for production. PM if interested.
Check Barlow's for the best selection and price on Component Systems paint.
As to your sprue. Move it off center so that it hits the mold at an angle, below the front of the jig. That way you can put the ring where you want w/o having to deal with the sprue. It should not make a difference in the pour as long as your lead is the proper temp !!
One last thing, I have several blank molds ( Do It ) if you desire to make your molds permanent for production. PM if interested.
Check Barlow's for the best selection and price on Component Systems paint.