Eskimo auger repair
|
Eskimo auger repair
|
01-03-2015, 01:20 AM
The problem with most 2 cycle motors is that they sit for months before they are used and that oil gums up the jets, causing them to run poorly, if at all. If you did not use the Seafoam until after you started having problems, that was likely the issue. It was likely too gummed up to help, unless you ran the motor for a long period of time.
[signature] |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Eskimo auger repair - by Dawgden - 12-31-2014, 10:14 PM
Re: [Dawgden] Eskimo auger repair - by wiperhunter2 - 01-01-2015, 03:59 AM
Re: [GSP] Eskimo auger repair - by GSP - 01-02-2015, 12:33 AM
Re: [GSP] Eskimo auger repair - by wiperhunter2 - 01-03-2015, 01:27 AM
Re: [wiperhunter2] Eskimo auger repair - by GSP - 01-04-2015, 12:34 AM
Re: [GSP] Eskimo auger repair - by wiperhunter2 - 01-04-2015, 04:41 PM
Re: [wiperhunter2] Eskimo auger repair - by Dawgden - 01-02-2015, 11:03 PM
Re: [Dawgden] Eskimo auger repair - by wiperhunter2 - 01-03-2015, 01:20 AM
|
