01-28-2015, 09:15 PM
No need for air or "Shad Keeper".
1.) Barrel 32 gallon size is great.
2.) Get a bilge pump 800 to 1200 GPH.
3.) get hose to fit bilge pump (8ft length)
Next are you going to mount it to the back part of the pontoon? or at another location on board the boat?
Drill a hole a 1-1/4 4" down from the top and another one 4" below that one.
One for fill (in) and one for overflow (out)
Hook up the hose to the tank and pump goes in the lake.
Hook up RV flex type hose to lower hole for the drain.
Use bulk-head fitting with hose connects.
[signature]
1.) Barrel 32 gallon size is great.
2.) Get a bilge pump 800 to 1200 GPH.
3.) get hose to fit bilge pump (8ft length)
Next are you going to mount it to the back part of the pontoon? or at another location on board the boat?
Drill a hole a 1-1/4 4" down from the top and another one 4" below that one.
One for fill (in) and one for overflow (out)
Hook up the hose to the tank and pump goes in the lake.
Hook up RV flex type hose to lower hole for the drain.
Use bulk-head fitting with hose connects.
[signature]