05-20-2016, 01:50 PM
[#0000FF]Have you checked with the manufacturer of the kayak? If the shell is vinyl you can use an adhesive rated for vinyl. I think Loctite makes a good one.
If the hull is strong enough, you may be able to drill a couple of holes and bolt it down...using a layer of silicone sealer between the hull and mount.
Otherwise, you could probably get the job done with any good waterproof epoxy.
Another good argument for float tubes and PVC.
Good luck.
[/#0000FF]
[signature]
If the hull is strong enough, you may be able to drill a couple of holes and bolt it down...using a layer of silicone sealer between the hull and mount.
Otherwise, you could probably get the job done with any good waterproof epoxy.
Another good argument for float tubes and PVC.
Good luck.
[/#0000FF]
[signature]