11-21-2019, 09:35 PM
That’s basically what I ended up doing. I installed a 3 bank onboard charger and mounted it up front in the battery box with the two trolling deep cycle batteries and then added an extension cable to one of the banks to reach the back cranking battery. It was a little tricky getting the wires all run through but I took apart the side panels and the entire back carpet. There were two sections I had to use a wire snake to pull the wire through but I needed to do that to install my new fish finder (Humminbird Helix 7) transducer cable also so it worked out doing both wires at the same time. Overall I’m very happy how it turned out. Now I can leave the batteries getting charged/maintained all year round and always know they are ready to go when I pull the boat out to fish.
[signature]
[signature]