Posts: 111
Threads: 0
Joined: Feb 2009
Reputation:
0
Just wondering what my chances are of catching a springer on the Fly over between Salmon and Ellis ??? How long will it take for the fish to get that far upstream?? This is all new to me Just hoping to catck a salmon next month. Will the same type of setup zI used on steelhead work for the Chinook?
[signature]
Posts: 126
Threads: 0
Joined: May 2010
Reputation:
0
I've gotten about 12-15 Springers to the bank on a fly rod,
You'll most likely need a 10wt although use what you have if it has a warranty! I've broken 2 ~ 8wts and a 9 wt on salmon and trying to get loose from a snag with 17lb tippet. A switch or spey rod,12-15 ft long really helps get the fly to the back side of the rocks were a lot of the salmon hide and hang out when they've had a rack full of hardware thrown at then by other chunkers on the bank. Find the 1st slow water above a bunch of rapids and the Nooks will hang and rest in the tail of that whole! I'm always amazed just how close they are to the head of those rapids !
On the Lochsa were I caught most of my salmon, they seem to like anything chartreuse over everything else!
Fly fishing and drift fishing is pretty much the same technique other than the cast and the weight. I use a sink tip wt dependent on water flow, to get down to the fish. I pretty much think that 50% of the fish hooked were flossed. Just like in Drift fishing?
Good Luck The Lochsa should be hopping in a week or two! I'm heading to Clear creek in the morning and working my way back up stream all weekend! I have rigs set up to mooch, drift, bobber and Fly!
[signature]
Posts: 2,727
Threads: 0
Joined: Nov 2005
Reputation:
0
I've caught 2 on an 8wt fly rod but in Alaska. Haven't fished for them on the Salmon River. I imagine a big issue might be casting far enough to reach holes containing them on a big river like that. Both of mine where caught while fishing for other salmon- sockeye and silvers on much smaller wadable rivers. I was using size 6-8 streamers each time. The fish were about 25 and 40 lbs and took 10-20 minutes to land. Maybe someone will chime in about catching them with a flyrod there but I imagine the catch rates are many times greater with other methods.
Posts: 126
Threads: 0
Joined: May 2010
Reputation:
0
I think the catch rate therory is dead on! In 2001 when the big run was on in the Lochsa, I didn't even look at my fly rod as an option until I had a punch card almost filled and that was early July when the River flow was more condusive to Fly rods and the clearity forced us sight fish and hunt them like Elk.
[signature]
Posts: 2,727
Threads: 0
Joined: Nov 2005
Reputation:
0
Osprey has good advise and I would go with the 10 wt rod if you have it. I was targeting smaller fish on a smaller river when I caught them with the 8 wt. I was using 12 lb leaders both times. That is the strongest line I will use with an 8 wt rod. I'd rather break my line than the rod.
[signature]
Posts: 111
Threads: 0
Joined: Feb 2009
Reputation:
0
I hear my temple fork 8 wt has a good warranty so I'll give it a go. I will probably also pick up a regular pole but have no clue on what to get. I need some pretty economical options any suggestions on a rod reel combo that will be up to the task?
[signature]
Posts: 2,727
Threads: 0
Joined: Nov 2005
Reputation:
0
Many inexpensive spinning rods can handle salmon. I fly fish 95+ % of the time so I don't spend a lot of money on spinning gear. My 12 yo son and my brother-in-law both caught king salmon on a 6' 6" medium action Shakespeare Excursion rod that came with a reel ( don't remember exactly which one) from Cabela's for about $70. We have caught 3-5 ft sharks as well with this model and we've never broke one yet.
[signature]