(09-04-2020, 02:14 PM)catchinon Wrote: The other day when I was dead in the water while landing a fish the boat drifted in such a way that the line of my second rod got wrapped into the inner part of the prop. Tried everything to get it out and finally had to just cut it off short on both ends. Will that cause any problem? I have no idea how to pull it apart and get that bit of line out.
Craig, you want to get that line out ASAP, or you run the risk of the line cutting the seal. There should be a nut on the outside and in the center of the prop that you can remove. Be careful where you remove it because there is likely a pin inside that will fall out and can easily be lost (it is not difficult to put it back in, but only if you haven't lost it).