Planer Board Basics
|
Planer Board Basics
|
05-31-2004, 12:51 AM
It would only marginally work, because it would be too low to work effectively. To make a planer board work properly one must get the line to the board as high above the water as possible. That is why rods designed to be used with planer boards are typically at least 8 feet long.
[signature] |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Planer Board Basics - by BearLakeMack - 05-30-2004, 03:25 PM
Re: [BearLakeMack] Planer Board Basics - by TheNails - 05-30-2004, 07:13 PM
Re: [BearLakeMack] Planer Board Basics - by Gumbo - 05-30-2004, 09:52 PM
Re: [BearLakeMack] Planer Board Basics - by cableguy - 05-30-2004, 10:34 PM
Re: [cableguy] Planer Board Basics - by kentofnsl - 05-31-2004, 12:51 AM
Re: [kentofnsl] Planer Board Basics - by Gumbo - 06-01-2004, 10:00 PM
Re: [BearLakeMack] Planer Board Basics - by Fishcrazy - 05-31-2004, 05:35 AM
|
