12-31-2010, 06:15 PM
I have an 83' Sears 'Ted Williams' gamefisher 9.9hp outboard that stopped spitting water out of the tiny hole on the back last time I used it in 2010. I noticed it and did not let the engine die by itself or over heat I dont think, I just shut it off and ran my electric.
I have finally obtained the impeller from Sears online and talked to Lee up at Lees Marine in Hyrum, but after speaking with him I dont have the jingle to pay him to do the work on it.
Is anyone familiar with this type of motor that can give me any advise on how to replace the impellar? I think there is a bearing I may need also?
any help is much appreciated!
tight lines.
I have finally obtained the impeller from Sears online and talked to Lee up at Lees Marine in Hyrum, but after speaking with him I dont have the jingle to pay him to do the work on it.
Is anyone familiar with this type of motor that can give me any advise on how to replace the impellar? I think there is a bearing I may need also?
any help is much appreciated!
tight lines.