Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Wanted: Marine Plywood
#29
I replaced the rivets with stainless sheet metal screws. I also squeezed a little bit of 3M 5200 silicone into each hole before screwing in to prevent water from seeping into each screw hole. So far, so good! It will be a pain if I ever have to remove said screws, but I hope that is a very long time. In the mean time, they're not going anywhere, and water is staying out.
[signature]
Reply


Messages In This Thread
Wanted: Marine Plywood - by megabite - 11-29-2012, 11:40 PM
Re: [wiperhunter2] Wanted: Marine Plywood - by Tarponjim - 04-22-2013, 12:44 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)